I applied online. The process took 1 week. I interviewed at Microchip Technology (Chandler, AZ) in June 2013
Interview
The interview process was fairly straight forward.
1. First a phone interview with the manager who had very basic but conceptual questios regarding digital VLSI and CMOS in general.
2. 6 on-site interviews including the HR round each of 45 mins. The questions asked covered the entire spectrum of digital design, VLSI design, CMOS basics and the physicl and RTL level design questions.
Interview questions [1]
Question 1
One of the questions was designing Flip-Flop with tri-state inverters.
I applied online. I interviewed at Microchip Technology in Dec 2025
Interview
There were two rounds of tech interviews. The panels were good to me and corrected me at times if I said anything wrong. Surprisingly my second went very well compared to first. Still I think I did not make it since there's nothing from the HR after that.
Interview questions [1]
Question 1
They asked me about my projects. Microcontrollers in depth, embedded C, basic analog concepts.
I interviewed at Microchip Technology (Burnaby, BC)
Interview
Basically an resume review. They asked me to talk about the projects on the resume. Also they took a look at my transcript and asked about some of the courses and what my favorite was.
Interview questions [1]
Question 1
Experience with digital logic projects like adders, clocks, MUX
Screening Round of 30 mins with hiring manager.
Five panel rounds each one hour based on RTL Verilog, Simulation, Debugging, Static Timing Analysis, CDC, Communication protocols such as UART, I2C, SPI.